Hytorc LITHIUM Series Operation Manual

31
CONVENTIONAL TORQUE LOOSENING
• The Tool provides the maximum torque capacity in reverse providing a powerful breakout capability.
• Press the center button to toggle to the loosen mode.
• When using conventional torque install a back wrench to keep the back nut from turning.
• Position the tool over the nut.
• Position the reaction arm against a firm surface.
• Pull and hold the trigger and any button on the rear panel to apply torque to loosen the nut.
• Once the tool starts the reaction arm will move against the reaction surface. The tool will then begin to loosen the nut.
• The status light will turn amber during operation. If the operation is successful, the status light will turn green, if
unsuccessful the status light will turn red.
• Remove the tool from the nut.
(CONT’D.)

Hytorc LITHIUM Series Specifications

General

Brand	Hytorc
Model	LITHIUM Series
Category	Tools
Language	English