Ibex Dental Technologies SUMMIT - Error Codes and Troubleshooting

40
The following is a listing of all the error codes by category.
Programming Errors
"Low Temp not within limits"
"Preheat Time not within limits"
"Heat Rate not within limits"
"Vacuum Level not within limits"
"High Temp not within limits"
"Vac Hold Time not within limits"
"Hold Time not within limits"
"Start Vac Temp not within limits"
"Set only Vac Hold or Release Vac"
"Clear Vac Hold or Release Vac"
"Release Vac not within limits"
"Cool Time not within limits"
Press Programming Errors
"Initial Soak Time not within limits"
"Press Hold not within limits"
"2nd Hold Temp not within limits"
"2nd Hold Time not within limits"
"2nd Heat Rate not within limits"
Set Up Errors
"Idling time out of range"
"Power Save temp out of range"
"Invalid Month specified!"
"Invalid Feb day for leap year!”
"Invalid Feb day!"
"Max day for month is 30!"
"Invalid Day specified!"
"Invalid hour for PM"
"Must be in the range of -5% to +5%"
Operational Errors
"Wait until door opens and press Run."
"Pressing not enabled!"
"Run-time error!"
"Could not achieve minimum vacuum level!"
"Could not reach vacuum!"
"Unable to hold vacuum!"
Error Codes