v After you enable AG mode, some fabric information is erased, such as the zone
and security databases.
v Enabling AG mode is disruptive because the switch is disabled and rebooted.
v Ensure that no zoning or Admin Domain (AD) transaction buffers are active. If
any transaction buffer is active, enabling Access Gateway mode will fail with the
error, “Failed to clear Zoning/Admin Domain configuration.”
Use the following steps to enable Access Gateway mode using Fabric OS
commands. For more information on enabling Access Gateway mode, refer to
“Enabling and disabling Access Gateway mode” in the Access Gateway
Administrator’s Guide.
1. Before disabling a switch to enable Access Gateway mode, save the current
configuration file using the configUpload command in case you need this
configuration again.
2. 2. Enter the switchShow command to verify the switch mode.
v Access Gateway Mode displays for switchMode if the switch is in Access
Gateway mode.
v Native displays for switchMode if the switch is in Fabric OS Native mode.
3. Enter switchDisable to disable the switch. Access Gateway mode can only be
enabled or disabled when the switch is in a disabled state.
4. Enter ag –modeEnable to enable Access Gateway mode.
5. Enter the ag --modeShow command to verify that AG mode is enabled.
switch:admin> ag --modeshow
Access Gateway mode is enabled.
Disabling Access Gateway mode
When you disable Access Gateway mode, the switch automatically reboots and
comes back online using the fabric switch configuration. The Access Gateway
parameters, such as F_Port-to-N_Port mapping, Failover, and Failback are
automatically removed. When the switch reboots, it starts in Fabric OS Native
mode. To re-join the switch to the core fabric, refer to the Access Gateway
Administrator’s Guide.
Use the following steps to disable Access Gateway mode using Fabric OS
commands. For more information, refer to the “Enabling and disabling Access
Gateway mode” section in the Access Gateway Administrator’s Guide.
1. Enter the switchShow command to verify the switch mode.
v “Access Gateway Mode” displays if the switch is in Access Gateway mode.
v Interopmode “0” or “Native” displays if the switch is in Fabric OS Native
mode.
2. Enter switchDisable to disable the switch. Access Gateway mode can only be
disabled or enabled when the switch is in a disabled state.
3. Enter ag --modeDisable to disable Access Gateway mode.
4. Enter the ag --modeShow command to verify that AG mode is disabled.
switch:admin> ag --modeshow
Access Gateway mode is NOT enabled
22 SAN48B-5 Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General