X'020202'
•
X'020405'
X'020202' Invalid IPDS Command Length
Explanation: The length for a command is not within the allowed range.
The length of a Request Resource List entry is not a valid or supported value.
The length specified for a Request Resource List entry does not match the
number of bytes received.
Alte rn a te Ex c e p tion Actio n : None.
X'020205' Invalid Data Structured Field Length
Explanation: A data structured field has been received in a WGC or WBCC
command that is less than the minimum allowable length.
Alte rn a te Ex c e p tion Actio n : None.
X'020302' IPDS Command Header Length Too Small
Explanation: The length of the IPDS command header is too small.
Alte rn a te Ex c e p tion Actio n : None.
X'020401' End Page Encountered During Active Suppression
Explanation: The End Page control was encountered before a text suppression
ended.
Alte rn a te Ex c e p tion Actio n : Process the object as if the corresponding End
Suppression control sequence appeared at the end of the object. That is, all of
the data following the Begin Suppression control sequence in the object is
processed and suppressed.
X'020402' Acknowledge Reply Response Continuation Request is Invalid
Explanation: The printer received a command whose response continuation bit
is on but there is no response to continue.
Alte rn a te Ex c e p tion Actio n : None.
X'020405' Area Position Reference System is Not Supported
Explanation: The reference system specified in the Area Position structured field
of the WGC or WBCC command is not a valid or supported value.
Alte rn a te Ex c e p tion Actio n : None.
Appendix A. IPDS Exception Reporting Codes 151
To Next Page
Loading...
Need help?
General