IBM 6400 Programmer's Reference

X'020501'
•
X'020605'
X'020501' Invalid Spanning Sequence
Explanation: A Write Text or Write Graphics command is required to complete a
partial order, control, or double-byte character code and another command was
received other than an XOA command.
Alte rn a te Ex c e p tion Actio n : None.
X'020502' Unsupported Baseline Move
Explanation: Unsupported advancement of the baseline coordinate toward the
I-axis.
Alte rn a te Ex c e p tion Actio n : None.
X'020505' Structured Field Unit-Base Invalid
Explanation: The unit-base (measurement units) specified in the Output Control
or the Data Descriptor structured field of the WGC or WBCC command is not a
valid or supported value.
Alte rn a te Ex c e p tion Actio n : None.
X'020601' Begin Suppression Error
Explanation: Begin Suppression encountered in the same unit (page, segment
or overlay) before previous suppression in that unit ended.
Alte rn a te Ex c e p tion Actio n : None.
X'020605' Structured Field Units Invalid
Explanation:
1. The units specified in the Output Control or the Data Descriptor structured
field of the WGC or WBCC command is not a valid or supported value.
2. The result of the calculation cannot be represented in the printer. This may
result from the WGC GDD window limits being very close together.
3. Coordinate overflow while scaling graphics. Possible if scaling coordinates
require multiplication by a value greater than 1.
Alte rn a te Ex c e p tion Actio n : None.
152 6400 IPDS

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English