2. Place the cover on the system. Align the pins inside the cover with the slots on the top of the chassis as
shown in the following gure.
Figure 132. Replacing and securing the cover
3. Slide the cover forwards until it latches into place.
4. Replace the 19 screws to secure the cover as shown in the following gure.
The system has 4 screws on each side, and 11 screws on the top surface. Use a #2 Phillips
screwdriver.
Figure 133. Replacing the cover screws
5. Replace the rails on both sides of the system.
a) Attach the rail to the system by placing the rail over the three support pins on the side of the
system. Ensure that each of the three support pins goes through the rail.
106
Power Systems: Servicing the IBM Power Systems HMC (7063-CR2)
To Next Page
Loading...
