IBM 7063-CR2 User Manual

Replacing a drive in the 7063-CR2 system
To replace a drive in the IBM Power Systems HMC (7063-CR2) system, complete the steps in this
procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the drive.
a) Support the drive by the bottom as you position the drive, and insert it into the drive slot.
Important: Ensure that the drive is fully seated and is all the way into the system.
b) Lock the drive bay handle (A) by pushing in the handle release latch until it locks into place.
12
Power Systems: Servicing the IBM Power Systems HMC (7063-CR2)

IBM 7063-CR2 Specifications

General

Brand	IBM
Model	7063-CR2
Category	Network Hardware
Language	English