Figure 69. Installing a power supply in the system
4. Reconnect the power cord.
For instructions, see “Connecting the power cords to a 7063-CR2 system” on page 101.
Removing and replacing the system backplane in the 7063-CR2
Learn how to remove and replace the system backplane in the IBM Power Systems HMC (7063-CR2)
system.
Before you begin
Removing or replacing this part is a customer task. You can complete this task yourself, or contact a
service provider to complete the task for you. You might be charged a fee by the service provider for this
service.
Before you begin replacing the system backplane, write down the system serial number and machine
model type. After you replace the system backplane, you must set the system serial number and machine
model type in the system backplane.
Preparing the 7063-CR2 system to remove the system backplane
To prepare to remove the system backplane from the IBM Power Systems HMC (7063-CR2) system,
complete the steps in this procedure.
Procedure
1. Make note of the system serial number and the machine model type. After you replace the system
backplane, you must set the system serial number and machine model type in the system backplane.
2. Make note of the BMC network settings. Record the BMC IP settings.
After you replace the system backplane, you might need to recongure the BMC network settings.
Removing and replacing parts in the 7063-CR2
53
To Next Page
Loading...
Need help?
General
