Figure 33. Replacing the air baffle in a stand-alone system
Removing and replacing covers on the 9040-MR9 system
Use these instructions to remove and replace the covers on a IBM Power System E950 (9040-MR9)
server so that you can access the hardware parts or perform service.
Removing and replacing front cover on a 9040-MR9 system
Use these instructions to remove and replace the front cover on a IBM Power System E950 (9040-MR9)
system so that you can access the hardware parts or perform service.
Removing the front cover from a 9040-MR9 system
Use this procedure to remove the front cover from a IBM Power System E950 (9040-MR9) server so that
you can access the components or perform service.
Procedure
1. If necessary, open the front rack door.
2. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
3. Place your ngers on the indentations and pull the latches (B) located on both sides of the cover as
shown in the following gure.
Pull the cover (A) away from the system.
48
Power Systems: Common procedures for installable features
To Next Page
Loading...
