Figure 58. Connecting the power cords to a stand-alone system
3. If applicable, close the rack door at the rear of the system.
Connecting the power cords to the 9040-MR9 system
Use this procedure to connect the power cords to an IBM Power System E950 (9040-MR9) server.
Procedure
1. If applicable, open the rack door at the rear of the system.
2. Using your labels, reconnect the power cords (A) to the system unit as shown in the following gure.
Fasten the power cords to the system by using the hook-and-loop fasteners (B) as shown in the
following gure.
82
Power Systems: Common procedures for installable features
To Next Page
Loading...
