IBM 9223-42H - Enabling enclosure or server indicators by using the ASMI; Control panel LEDs

Enabling enclosure or server indicators by using the ASMI
Find out how to enable enclosure or server indicators by using the Advanced System Management
Interface (ASMI).
About this task
To perform this operation, you must have one of the following authority levels:
• Administrator
• Authorized service provider
To enable the enclosure or server indicator states, complete the following steps:
Procedure
1. On the ASMI Welcome pane, specify your user ID and password, and click Log In.
2. In the navigation area, expand System Conguration > Service Indicators > Enclosure Indicators.
A list of enclosures is displayed.
3. Select the enclosure and click Continue.
A list of location codes is displayed. Alternatively, you can click Indicators by Location Code and type
the location code in the Location code eld.
4. In the Identify indicator status eld, select Identify.
5. To save the changes that are made to the state of an indicator, click Save settings.
Control panel LEDs
Use this information as a guide to the control panel LEDs and buttons.
Use Figure 1 on page 5
with the control panel LED descriptions to understand the system status that is
indicated by the control panel.
Figure 1. Control panel LEDs
Control panel LEDs and descriptions:
• A: Power-on button
– A constant green light indicates full system power to the unit.
Common procedures for installable features
5