a. Using a screwdriver or a coin, turn each of the screws toward the middle of
the blade server until they are in the unlocked position.
b. While you lift the back of the access panel, slide the panel away from the
bezel.
3. Remove the hypervisor interposer:
a. Locate the hypervisor interposer on the system board (see “Major
components of the blade server” on page 12).
b. Press down on the front edge of the hypervisor interposer to disengage the
hypervisor interposer from the hypervisor interposer card guide.
c. Carefully lift the hypervisor interposer up from the system board.
4. Touch the static-protective package that contains the hypervisor key to any
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component in the rack in which you are installing
the hypervisor key for at least 2 seconds; then, remove the USB module from
its package.
5. Install the hypervisor key into the hypervisor adapter:
a. Orient the connector on the hypervisor key with the connector on the
hypervisor adapter.
b. Use your fingers to push the hypervisor key into the hypervisor adapter.
6. Install the hypervisor adapter:
a. Orient the connector on the hypervisor interposer with the interposer
connector on the system board, aligning the pins on the side of the
hypervisor interposer with the pinholes on the interposer connector (see
“Blade server connectors - BladeCenter HX5” on page 21).
b. Use your fingers to push the adapter into the connector on the blade server.
Attention: Be careful not to damage the pins on the hypervisor interposer.
7. Install the access panel if you have standard heat sinks installed.
Note: If you have the tall heat sinks installed, you do not need to install the
access panel.
44 IBM BladeCenter HX5 Type 7873, 7872, 1910, and 1909: Installation and User's Guide
To Next Page
Loading...
Need help?
General