IBM BladeCenter HX5 User Manual

asu set SYSTEM_PROD_DATA.SYsInfoProdName m/t_model --user
imm_user_id--password imm_password
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum s/n--user imm_user_id
--password imm_password
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag asset_tag --user
imm_user_id--password imm_password
Examples that do use the user ID and password default values: asu set
SYSTEM_PROD_DATA.SysInfoProdName m/t_model asu set
SYSTEM_PROD_DATA.SysInfoSerialNum s/n asu set
SYSTEM_PROD_DATA.SysEncloseAssetTag asset_tag
v Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this
access method.
The KCS access method uses the IPMI/KCS interface. This method requires
that the IPMI driver is installed. Some operating systems have the IPMI
driver installed by default. ASU provides the corresponding mapping layer.
See the Advanced Settings Utility Users Guide for more details. You can access
the ASU Users Guide from http://www.ibm.com/systems/support/
supportsite.wss/docdisplay?lndocid=TOOL-ASU&brandind=5000016.
The following commands are examples of using the user ID and password
default values and not using the default values:
Examples that do not use the user ID and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName m/t_model
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum s/n
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag asset_tag
v Remote LAN access. Use the following syntax:
Note: When using the remote LAN access method to access IMM using the
LAN from a client, the host and the imm_external_ip address are required
parameters.
host imm_external_ip [user imm_user_id][password imm_password]
imm_external_ip
The external IMM LAN IP address. There is no default value. This
parameter is required.
imm_user_id
The IMM account (1 of 12 accounts). The default value is USERID.
imm_password
The IMM account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero, not the letter O).
The following commands are examples of using the user ID and password
default values and not using the default values:
Examples that do not use the user ID and password default values:
asu set SYSTEM_PROD_DATA.SYsInfoProdName m/t_model--host imm_ip --user
imm_user_id --password imm_password
asu set SYSTEM_PROD_DATA.SYsInfoSerialNum s/n --host imm_ip --user
imm_user_id--password imm_password
asu set SYSTEM_PROD_DATA.SYsEncloseAssetTag asset_tag--host imm_ip
--user imm_user_id --password imm_password
Examples that do use the user ID and password default values:
Chapter 4. Configuring the blade server 81

IBM BladeCenter HX5 Specifications

General

Brand	IBM
Model	BladeCenter HX5
Category	Server
Language	English