Table 33. Feature codes for power cords (continued)
Feature code Rated voltage/current Input connector Input connector
diagram
1041 Three-phase power
cord, 250 V, 32 A (ve-
pin Wye)
IEC 309 3P+N+Gnd
1042 Single-phase power
cord, 250 V, 32 A
For use in Australia and
New Zealand (not IEC
309)
1043 Single-phase power
cord, 250 V, 30 A
For Korea
1044 Single-phase power
cord, 250 V, 32 A
IEC 309 P+N+Gd
halogen free
Conguration rules for power features
Ensure that you are familiar with the conguration rules and feature codes before you order power
features.
When you order power cord features, the following rules apply.
• You must order a minimum of one power cord feature for each frame. Each feature code represents a
pair of power cords (two cords).
• You must select the power cord that is appropriate to the input voltage and geographic region where the
storage system is located.
Other conguration features
Features are available for shipping and setting up the storage system.
You can select shipping and setup options for the storage system. The following list identies optional
feature codes that you can specify to customize or to receive your storage system.
• BSMI certicate (Taiwan)
• Shipping weight reduction option
BSMI certicate (Taiwan)
The BSMI certicate for Taiwan option provides the required Bureau of Standards, Metrology, and
Inspection (BSMI) ISO 9001 certication documents for storage system shipments to Taiwan.
If the storage system that you order is shipped to Taiwan, you must order this option for each model that
is shipped.
66
IBM DS8900F: DS8900F Introduction and Planning Guide
To Next Page
Loading...
Need help?
General