Press the Enter key to continue.
Note: There is a known issue with this check that might result in the following error.
If you see the "Unsupported NVMe Drive.." message, it is likely that the code is incorrectly looking
for a "G3" NVMe Drive type. To conrm this is not a real error do the following:
i) Exit essutils and log in as the root user.
ii) Run the command nvme --list.
Inspect the output and ensure that none of the drive models have "G3" in them.
For example:
3.84TB NVMe G3 Tier-1 Flash
If so, this drive needs to be replaced. If no drives have "G3", log in again as essserv1 and continue
with the code 20 flow.
l. Highlight the Check enclosure cabling and paths to disks menu and press the Enter key.
This option checks the valid status of all paths to the NVMe drives.
Figure 61. Checking enclosure cabling and paths to disks
The output displays with a PASS or ERROR message. If the step fails with an error message,
debug the issue and try again.
Press the Enter key to continue.
m. Highlight the Check disks for IO operations menu and press the Enter key.
This option checks the health status of all the drives by performing a simple read/write test to
each drive. This check takes around 5 seconds for each drive.
You would be asked to conrm by typing Yes and press the Enter key as shown in the following
gure.
Chapter 4. Installing
71
To Next Page
Loading...
Need help?
General