Chapter 3: Switch Management 41
For example, to configure the management interface with an IPv6
address/prefix of 2001:DB8:132::3/32 and a default gateway of
2001:DB8:132::1/32, enter the following commands:
network ipv6 address 2001:DB8:132::3/32
network ipv6 gateway 2001:DB8:132::1
5. To verify the configured information, enter the following command:
(CN1610) #show network
Interface Status................... Up
IP Address.......................... 192.168.2.23
Subnet Mask......................... 255.255.255.0
Default Gateway..................... 192.168.2.1
IPv6 Administrative Mode............ Enabled
IPv6 Prefix is ..................... fe80::210:18ff:fe82:64c/64
IPv6 Prefix is ..................... 2001:DB8:132::3/32
IPv6 Default Router is ............. 2001:DB8:132::1
Burned In MAC Address............... 00:10:18:82:06:4C
Locally Administered MAC address.... 00:00:00:00:00:00
MAC Address Type.................... Burned In
Configured IPv4 Protocol ........... None
Configured IPv6 Protocol ........... None
DHCPv6 Client DUID .............. 00:03:00:06:00:10:18:82:06:4C
IPv6 Autoconfig Mode................ Disabled
Management VLAN ID.................. 1
6. Optionally, to save the current configuration so all changes are retained
during a switch reset, enter:
write memory
To Next Page
Loading...
Need help?
General