IBM N Series - User Manual

168 pages

Save Page as PDF

To Next Page

IB M System Storag e N series

Data ONTAP 8.0. 4 7-Mod e R e l ease

Notes

GA32-0723-15



Main Page

Other manuals for IBM N Series

Installation Guide62 pages

Hardware Guide368 pages

Questions and Answers

O
orobinsonJul 31, 2025
What to do if IBM N Series system does not boot?
- D
  Don TranJul 31, 2025
  If your IBM Storage system doesn't boot when powered on, start by looking for a description of the problem on the console and follow any instructions provided. Make sure all cables and connections are secure and that power is supplied to your system from the source. Also, verify that the power supplies on your controller and disk shelves are working. If a power supply isn't illuminated, remove and reinstall it, ensuring it connects with the backplane. Check disk ownership to ensure disks are assigned to the system. Turn off your controller and disk shelves, then turn on the disk shelves. If the system still doesn't start, contact IBM technical support, as the system might be missing the boot image on the boot device.
J
James KentNov 14, 2025
What to do if my IBM Storage system does not boot?
- T
  Tonya FergusonNov 14, 2025
  If your IBM Storage system fails to boot when powered on, start by looking for a problem description on the console and follow any provided instructions. Ensure all cables and connections are secure, and verify that the power supply is properly connected to the system. If the system is still not starting, remove and reinstall the power supply, ensuring it connects with the backplane. Check the disk ownership to ensure the disks are assigned to the system. Also, validate that storage is attached to the system and verify any changes by running the disk show -v command. In addition, verify disk shelf compatibility and check the disk shelf IDs. If you have mixed DS14mk2 and DS14mk4 Fibre Channel shelves, set the shelf speed to 2 Gb, regardless of module type. Try turning off your controller an...