Requirements for running Data ONTAP 8.0 7-Mode
You can verify whether you have the storage systems and firmware needed to
run the software in the Data ONTAP 8.0 7-Mode release family.
To find out your storage system model's capacity and maximum volume size,
see the IBM System Storage N series Introduction and Planning Guide.
Supported systems
You need one of the supported storage systems listed in this section to run a
release in the Data ONTAP 8.0 7-Mode family.
The following models of storage systems are supported:
v N5300 and N5600 storage systems
v N3400 storage systems
v N6000 series systems
v N6200 series systems
v N7000 series systems
v N7x50T
All systems supported by Data ONTAP 8.0 7-Mode release family can be
configured as a high-availability pair.
Unsupported systems
There are some storage systems that are not supported in Data ONTAP 8.0
7-Mode.
The following N series storage systems models are not supported in Data
ONTAP 8.0 7-Mode and later Data ONTAP 8.0.x 7-Mode releases:
v N3220, N3240, N3300, and N3600 storage systems
v N5200 and N5500 storage systems
Maximum total capacity supported
For information about each storage system model's capacity and maximum
volume size, see the IBM System Storage N series Introduction and Planning
Guide.
© Copyright IBM Corp. 2012 61
To Next Page
Loading...
