IBM N Series - New Commands in Data ONTAP 8.0 7-Mode

New commands in Data ONTAP 8.0 7-Mode
Many new commands have been added in the Data ONTAP 8.0 7-Mode
release family.
For each command family and each command, the following table gives this
information:
v The purpose of the command
v The location of documentation about the feature
v The Data ONTAP 8.0 7-Mode release in which the command was
introduced
Command Purpose Documentation Release introduced
acpadmin configure Configures the ACP
subsystem.
Data ONTAP 8.0
7-Mode Storage
Management Guide
na_acpadmin(1)
man page
8.0
acpadmin list_all Displays information about
the ACP (Alternate Control
Path) storage subsystem.
Data ONTAP 8.0
7-Mode Storage
Management Guide
na_acpadmin(1)
man page
8.0
bmc battery-info Displays battery information,
for example, battery name,
charging status, serial number,
part number, firmware and
hardware versions, chemistry
type, manufacturer, and date
of manufacture.
na_bmc(1) man
page
8.0.4
cdpd Displays information about
devices that advertise
themselves by using the
CDPv1 protocol.
Data ONTAP 8.0
7-Mode Network
Management Guide
8.0.1
du Displays the files and amount
of space that they occupy in a
deduplicated volume.
Data ONTAP 8.0
7-Mode Storage
Management Guide
8.0.1
ifgrp Manages interface groups on
your storage system.
This command replaces the
vif command. However, the
options remain the same.
Data ONTAP 8.0
7-Mode Network
Management Guide
8.0
48 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes