IBM N Series - Page 59

Command Purpose Documentation Release introduced
revert_to Transitions Data ONTAP to a
release in an earlier release
family
Data ONTAP 8.0
7-Mode Upgrade and
Revert/Downgrade
Guide
revert_to(1) man
page
8.0
smtape abort Aborts a backup or restore job
initiated by the SMTape
engine.
Data ONTAP 8.0
7-Mode Data
Protection Tape
Backup and Recovery
Guide
na_smtape man
page
8.0
smtape backup Backs up blocks of data to
tape.
Data ONTAP 8.0
7-Mode Data
Protection Tape
Backup and Recovery
Guide
na_smtape man
pages
8.0
smtape continue Continues an SMTape-initiated
backup or restore operation
after it has reached the end of
current tape and is in the wait
state to write output to or
accept input from a new tape.
Data ONTAP 8.0
7-Mode Data
Protection Tape
Backup and Recovery
Guide
na_smtape man
page
8.0
smtape restore Restores blocks of data from
tape.
Data ONTAP 8.0
7-Mode Data
Protection Tape
Backup and Recovery
Guide
na_smtape man
page
8.0
smtape status Display the status of
SMTape-initiated backup and
restore operations
Data ONTAP 8.0
7-Mode Data
Protection Tape
Backup and Recovery
Guide
na_smtape man
page
8.0
New and changed commands and options 49