aggr add aggr1 4@635G
Discovering what disks Data ONTAP will automatically select
To list which disks would be selected, use the -n option for the aggr create
or aggr add command.
When you use the -n option, the disks that would be selected automatically, if
you created an aggregate or added to an aggregate, are displayed. The
operation is not performed. If the selected disks are not what you intended,
you can specify a disk list when you enter the aggr create or aggr add
command.
To list the disks that would be selected for an aggr create command, enter
the following command:
aggr create aggr_name -n disk_list
Example
For example, to list the disks that would be used for the creation of the
newaggr aggregate using eight automatically selected disks, enter the
following command:
aggr create newaggr -n 8
SSD Spare blocks consumed limit reported as N/A
When Data ONTAP reports status information for SSDs, the Spare blocks
consumed limit value is displayed as N/A. The limit for currently shipping
SSDs is 90%.
Known problems and limitations 93
To Next Page
Loading...
Need help?
General