Note: Do not add CIFS commands to /etc/rc. Doing so can cause
problems when the storage system boots if CIFS is not fully initialized or
the commands cause deadlocks between the /etc/rc file and CIFS.
3. Ensure that entries in the /etc/rc file are listed in the following order:
hostname system_name
ifgrp commands
vlan commands
ifconfig commands
vfiler commands
route commands
[any other commands]
4. Save the edited file.
5. Reboot the storage system to test the new configuration. If the new
configuration does not work as you want, repeat Step 2 through Step 4.
Terminology changes for PAM and WAFL extended cache
In the Data ONTAP 8.0 7-Mode System Administration Guide, mentions of
"Performance Acceleration Module (PAM) family" should be amended to read
"Performance Acceleration Modules (PAM) and Flash Cache Modules", and
mentions of "WAFL extended cache" should be amended to read "WAFL
external cache".
Corrections for root FlexVol volume size requirement
The size requirement for root FlexVol volumes on some systems has changed.
In the section titled Size requirement for root FlexVol volumes in the Data
ONTAP 8.0 7-Mode System Administration Guide, the table is amended with the
following information:
Storage system model Minimum root FlexVol volume size
N6210 151 GB
N6240 205 GB
Changes to the root aggregate and root volume Snapshot reserve values
on new systems
Starting with Data ONTAP 8.0.1, new systems are shipped with Snapshot
reserve for the root aggregate set to 0 percent and Snapshot reserve for the
root volume set to 5 percent.
The default reserve value for other aggregates or volumes remains the same.
Existing systems are also not affected by this change.
The following note no longer applies and is considered removed from the
section titled Aggregate Snapshot Reserve in the Data ONTAP 8.0 7-Mode
System Administration Guide.
126 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
Need help?
General