IBM N Series - Firmware

Changed commands in Data ONTAP 8.0 7-Mode
This table lists the commands that have been changed in the Data ONTAP 8.0
7-Mode release family.
For each command family and each command, the following table gives this
information:
v The change in the command
v The location of documentation about the feature
v The Data ONTAP 8.0 7-Mode release in which the change was introduced
Command Change Documentation
Release
command
changed in
aggr create The -B option has been
added. This option is used
to create a 64-bit aggregate.
na_aggr(1) man page
Data ONTAP 8.0
7-Mode Storage
Management Guide
8.0
df The -x option has been
added. This option
suppresses the display of
the .snapshot lines.
na_df(1) man page 8.0
disk assign You can no longer use this
command to change the
ownership of a disk or
array LUN that is already
owned unless you are
running the command on
the system that owns the
disk already.
na_disk(1) man page 8.0
environment shelf The Complex
Programmable Logic Device
(CPLD) version has been
added to the output.
na_environment(1)
man page
8.0
flexcache fstat The -inode-file option has
been added. This option
displays the number of
blocks used by the
FlexCache volume's inode
file.
na_flexcache(1) man
page
8.0.3
52 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes