IBM N Series User Manual

Command Change Documentation
Release
command
changed in
halt The -s option no longer
powers off the controller.
Instead, it halts at the
LOADER prompt. For
systems that have FRU
fault LEDs on the
motherboard, Data ONTAP
also clears the LEDs when
subsequently booted.
na_halt(1) man page 8.0.4
ifgrp create multi The port value (port-based
load-balancing) for the -b
option has been added.
Data ONTAP 8.0
7-Mode Network
Management Guide
8.0.1
software update The -r option, which
suppresses automatic
reboot, is now the default.
To request an automatic
reboot, you now must
specify the -R option.
na_software(1) man
page
Data ONTAP 8.0
7-Mode Upgrade and
Revert/Downgrade
Guide
8.0.1
storage show acp A column for Module type
has been added to the
output. This shows the type
of the I/O module.
na_storage(1) man
page
8.0.1
storage show expander The system interconnect
link (SIL) ports (the last
four rows of output) are
now shown as [SIL0]
through [SIL3]. Previously
they were shown as [DIS0]
through [DIS3].
na_storage(1) man
page
8.0
storage show expander The EXN3000 and EXN3500
storage expansion unit
ports are now listed as
[SQR0]-[SQR3] for the
square ports and
[CIR4]-[CIR7] for the circle
ports. Previously these
ports were listed as [IO
0]-[IO7].
na_storage(1) man
page
8.0
New and changed commands and options 53

IBM N Series Specifications

General

Brand	IBM
Model	N Series
Category	Storage
Language	English