IBM N Series - Changes Introduced Since Data ONTAP 8.0

Changes introduced since Data ONTAP 8.0
If you are already familiar with an earlier release in the Data ONTAP 8.0
7-Mode family you can see changes introduced with each release in the Data
ONTAP 8.0 7-Mode family.
Note: If you are new to the Data ONTAP 8.0 family, it is not necessary to
read this section; you can go directly to “New and changed features” on page
17.
v “Changes introduced in Data ONTAP 8.0.4 7-Mode release”
v “Changes in the Data ONTAP 8.0.3 7-Mode release” on page 5
v “Changes in the Data ONTAP 8.0.2 7-Mode release” on page 9
v “Changes in the Data ONTAP 8.0.1 7-Mode release” on page 13
Changes introduced in Data ONTAP 8.0.4 7-Mode release
The Data ONTAP 8.0.4 7-Mode release includes hardware and software
enhancements, and problem fixes.
New or changed features in Data ONTAP 8.0.4 7-Mode
Data ONTAP 8.0.4 7-Mode includes the following new feature:
v “Support for 900-GB SAS disks” on page 21
For information about all new and changed features in the Data ONTAP 8.0
7-Mode release family, see “New and changed features” on page 17.
New commands in Data ONTAP 8.0.4 7-Mode
Data ONTAP 8.0.4 7-Mode introduces the following new command:
v bmc battery-info
For more information, see “New commands in Data ONTAP 8.0 7-Mode” on
page 48.
Commands removed in Data ONTAP 8.0.4 7-Mode
No commands are removed in Data ONTAP 8.0.4 7-Mode.
For more information, see “Replaced or removed commands in Data ONTAP
8.0 7-Mode” on page 56
© Copyright IBM Corp. 2012 3