EasyManuals Logo

IBM N Series User Manual

IBM N Series
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #86 background imageLoading...
Page #86 background image
Network protocol cautions
This information addresses network protocols cautions. Review the following
section for important information regarding network management.
For more information about these issues, see the Data ONTAP 8.0 7-Mode
Network Management Guide.
v “System might panic if the network configuration entries in the /etc/rc file
are not in the recommended order”
v “Reconfiguring the losk interface results in system outage”
v “IPv6 is not supported”
v “IPsec is not supported”
v “TOE is not supported”
System might panic if the network configuration entries in the /etc/rc file
are not in the recommended order
You should ensure that the entries in the /etc/rc file are in the recommended
order. The incorrect order can cause prolonged giveback or system reboot
time, which might result in a system panic.
For more information about the ordering of entries in the /etc/rc file, see the
Data ONTAP 8.0 7-Mode System Administration Guide.
Reconfiguring the losk interface results in system outage
If you modify the default configuration of the losk interface, it can result in a
system outage. If any IP address or routing configurations related to the losk
interface exists in the /etc/rc file, you must remove these configurations to
avoid undesirable behavior of the storage system.
IPv6 is not supported
IPv6 is not supported in Data ONTAP 8.0 and later. If you want to upgrade
from a Data ONTAP version that supports IPv6 to Data ONTAP 8.0 or later,
see the Data ONTAP 8.0 7-Mode Upgrade and Revert/Downgrade Guide.
IPsec is not supported
IPsec is not supported in Data ONTAP 8.0 and later. If IPsec is enabled on
your storage system, be aware that it will be disabled automatically during
the upgrade to the Data ONTAP 8.0 release family.
TOE is not supported
In Data ONTAP 8.0 7-Mode and later Data ONTAP 8.0.x 7-Mode releases, the
TOE functionality is not supported. There is no adverse effect on the
performance of your storage system because TOE is disabled.
76 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes

Table of Contents

Other manuals for IBM N Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM N Series and is the answer not in the manual?

IBM N Series Specifications

General IconGeneral
BrandIBM
ModelN Series
CategoryStorage
LanguageEnglish

Related product manuals