Changes to the Storage Management Guide
New information has become available since the previous revision of the Data
ONTAP 8.0 7-Mode Storage Management Guide.
v “Corrections to the data compression commands”
v “Correction to the availability of FlexClone files and FlexClone LUNs in
vfiler contexts” on page 129
v “Capacity information for 3-TB disks” on page 129
v “Use FlexShare with HDDs only” on page 124
v “Maximum volume size for deduplication” on page 129
v “Incorrect cross-reference to maximum volume size information” on page
129
v “Maximum number of mirrored aggregates per system” on page 129
v “ACP example output shows incorrect IP addresses” on page 129
v “Using disk sanitization to remove data from disks” on page 130
Corrections to the data compression commands
The sections Decompressing the compressed data and Reverting compressed volumes
include incorrect command syntax for the data compression commands.
In the section Decompressing the compressed data, the existing command syntax
to decompress the compressed data is incorrect. The corrected command
syntax is as follows:
vol decompress start volume_name
In the section Reverting compressed volumes, the existing command syntax to
revert a volume and the example are incorrect. The corrected command syntax
and example are as follows:
vol decompress revert volume_name
volume_name is the name of the volume.
Example
The following command reverts the volume VolA, which contains compressed
data:
vol decompress revert VolA
128 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
Need help?
General