You can include the name of the hosting storage system as part of the vFiler
unit name so that you can easily determine the storage system that contains
the vFiler unit —for example, mycompanyss1_vfiler1.
v The name vFiler0 should not be used because it is the name of the default
vFiler unit.
SnapMirror relationship schedules are not modified for existing volumes
In Data ONTAP 8.0.2 and later releases, if you edit the SnapMirror
relationship schedules in the etc/snapmirror.conf file after executing the
vfiler dr configure command, the vfiler dr resync command does not
modify the SnapMirror relationship schedules for the existing volumes.
For example, if you change the SnapMirror relationship schedule from
asynchronous to semi-synchronous after executing the vfiler dr configure
command, the vfiler dr resync command does not modify the SnapMirror
relationship schedule from semi-synchronous to asynchronous during
resynchronization of the vFiler unit.
Corrections to the List of RSH and SSH commands
"List of RSH and SSH commands" topic lists some commands that are not
supported in Data ONTAP 8.0 and later releases.
The following commands, which are listed in the Data ONTAP 8.0 7-Mode
MultiStore Management Guide, are not supported in Data ONTAP 8.0 and later
releases:
cifs snap
config snapmirror
df snapvault
dns vol
echo vscan
fpolicy wcc
nbtstat ypcat
nfs ypgroup
nis ypmatch
route ypwhich
sectrace
Corrections to the SnapVault support on vFiler units
The sections "Where to enter SnapVault commands" and "Features and
limitations of the snapvault command" have some incorrect information about
interoperability between SnapVault and MultiStore.
Changes to published documentation 145
To Next Page
Loading...
Need help?
General