Command Change Documentation
Release
command
changed in
storage show fault You can now specify a
storage expansion unit
name for this command to
see information about a
specific storage expansion
unit.
na_storage(1) man
page
8.0.1
sysconfig When the -r option is used
to display disk information
for SAS-connected disks,
the CHAN (channel)
column now displays the
port as "A" or "B", just as it
does for FC-connected
disks. Previously, "1" and
"2" were used.
na_sysconfig(1) man
page
8.0
sysconfig When the -a option is used,
the output includes status
and power information for
any IOXM modules present.
na_sysconfig(1) man
page
8.0.1
sysconfig When the -v option is used,
any disabled ports show
"N/A" for the data link
rate.
na_sysconfig(1) man
page
8.0.2
vif This command has been
replaced by the ifgrp
command.
Data ONTAP 8.0
7-Mode Network
Management Guide
8.0
vol options The extent option enables
extents but can only be
used on FlexVol volumes.
na_vol(1) man page
and the Data ONTAP
8.0 7-Mode System
Administration Guide
8.0
vol options The read_realloc option
enables read reallocation
but can only be used on
FlexVol volumes.
na_vol(1) man page 8.0
vol status When the -r option is used
to display disk information
for SAS-connected disks,
the CHAN (channel)
column now displays the
port as A or B, just as it
does for FC-connected
disks. Previously, 1 and 2
were used.
na_vol(1) man page 8.0
54 IBM System Storage N series: Data ONTAP 8.0.4 7-Mode Release Notes
To Next Page
Loading...
