86 IBM Desktop System HMM
Cover
•
Disconnect the system unit power cord.
•
Remove the 3 screws at the back of the tower.
•
Insert a screwdriver under one of the tabs on the
back of the cover and gently pry the tower cover so
that it separates from the tower.
•
Slide the cover back about half inch (or 1.25
centimeters).
•
Lift the cover up by the top front and back edges,
pulling the sides out and away from the tower.
NOTE:
To prevent the tower from tipping over, you
may want to lay the tower on its side on a work
surface, such as a table.
To Next Page
Loading...
