66 IBM Desktop System HMM
Monitor
First, set the system to VGA mode. To do this in
Windows ME or Windows 2K, depress the F8 function
key during startup. Safe mode (VGA) will be set for
Windows ME or Windows 2K. Use the operating
system's video setup to change the monitor
resolution.
The monitors that come with the system are DDC2A/
B or DDC1/2B+ (Display Data Channel) compliant.
While starting Windows ME or Windows 2K, the
DDC2 monitor passes resolution and frequency
information to the system. The system interprets the
data and sets up the proper refresh rate.
If the monitor type is set to the power saving mode,
the screen remains black and the LED lights or
flashes in amber color. When the monitor is turned on
alone, or is turned on and connected to a powered-off
system unit, the monitor LED blinks in amber color.
Under the normal operating conditions, the LED lights
in green color.
NOTE:
Some monitors have a detachable system I/O
signal cable between the monitor and the
system unit. Check the line voltage, power
cord, and continuity for the system I/O signal
cable before replacing the monitor. See
“Monitor Port Signals” on page 135 for pin
identification.
001 - START
•
Power off the system unit and monitor.
•
Remove all adapter cards.
•
Make sure that the monitor I/O signal cable is
properly connected to the system unit and monitor.
•
Make sure that the power cords are properly
connected to the system unit and monitor, and that
the line voltage is correct.
•
Make sure that the monitor contrast and
brightness controls are not turned too low.
•
Make sure that the diagnostics diskette is in the
diskette drive.
•
Power on the monitor, and wait 20 seconds.
•
Power on the system unit.
To Next Page
Loading...
