88 IBM Desktop System HMM
Bay Panels
If you remove a drive from a bay and you do not
intend to install a new drive immediately, reinstall the
bay panel on the empty exposed drive bay.
Follow these steps to remove the plastic bay panel
from the front of the system unit cover.
•
Insert a flat-blade screwdriver into the slot on the
bay panel in the drive bay into which you are
installing the drive. Gently pry the bay panel loose
from the drive bay.
NOTE:
Replace the EMI Bay Panel
•
Replace the EMI bay cover.
•
Insert a bay panel into the opening at the front of
the system cover, aligning the panel latches with
the sides of the unit.
•
Push the panel back until you hear the latches
click into place.
To Next Page
Loading...
