IBM NetVista - Installing Expansion Adapters; Chapter 5: Using the IBM Setup Utility Program; Starting the Setup Utility; Viewing and Changing Settings

Check Procedures 45
Modem ring cannot wake up
system from suspend mode.
1. Ensure the “Modem
Wake-Up on Ring” in
Configuration/Setup
Utility is set to
[Enabled]. “Power
Management” on page
5.
2. If PCI modem card is
used, reinsert the
modem card to PCI slot
firmly or replace
modem card.
3. If ISA modem card is
used, ensure the
modem ring-in cable
from the modem card
to system board CN16
is connected properly.
See “System Board
Jumpers and
Connectors” on page
113.
4. In Windows ensure that
telephone application is
configured correctly for
your modem and set to
receive messages and/
or fax.
Video and Monitor
Video memory test failed.
Video adapter failed.
1. Remove all non
factory-installed cards.
2. Load default settings (if
screen is readable).
3. System board
Display problem:
- Incorrect colors
- No high intensity
- Missing, broken, or
incorrect characters
- Blank monitor(dark)
- Blank monitor(bright)
- Distorted image
- Unreadable monitor
- Other monitor problems
1. Monitor signal
connection/cable.
2. Monitor
3. Video adapter card
4. System board
Error Symptoms Action/FRU