Performing a Power-on Reset:
1. Select Options from the action bar.
2. Select Exit from the pull-down.
3. Open Task List from the Views area
4. Open CPC Recovery from the Task List Work Area
5. Open Groups from the Views area
6. Select CPC from the Groups Work Area
7. Drag and drop the selected object on Power-On-Reset in the CPC Recovery area
The Power-on Reset panel displays.
8. Under the title of Mode, select ESA/390
9. Under the title of Input/output configuration data sets (IOCDS), select the data set you just built.
10. Select OK.
The Change Storage Sizes panel displays.
11. Select OK.
The Confirm the Action panel displays.
12. Select Power-on reset
A power-on reset in progress panel displays while the power-on reset is performed. A power-on reset
takes approximately 5 minutes to complete. When complete, a message displays confirming the function
is complete.
13. Select OK on the Power-on Reset message panel.
Starting the IOCP Program:
1. Open Task List from the Views area
2. Open CPC Configuration from the Task List Work Area
3. Open Groups from the Views area
4. Select CPC from the Groups Work Area
5. Drag and drop the selected object on Input/output (I/O) configuration in the CPC Configuration
area
The Input/Output Configuration panel displays.
If the data set you want to change is write protected, select the data set, then select Options from the
action bar, then select Disable write protection from the pull-down.
Chapter 3. Beginning to Use Your System 3-9
To Next Page
Loading...
