3. Initiate shutdown and power off the machine by clicking Start > Shutdown or
by following the procedure for your business.
4. Continue with the steps described in “Replacing and rebuilding a hard disk drive
(Models xx4)” on page 69.
Method two: Entering RAID during startup
1. Shut down and reboot the machine by clicking Start > Shutdown or follow the
procedure for your business.
2. During the reboot, Figure 49 on page 69 displays information about the failing
disk. Make note of which drive is the failing disk. The failing drive is shown as
'Broken' or 'Failed' under the Status heading.
Figure 48. Viewing the hard drive and volume status
68 SurePOS 700-723/743/783/784 Hardware Service Guide
To Next Page
Loading...
Need help?
General
