Attaching an External Monitor
Note:
Refer to the specifications for your
external monitor to determine its
supported resolutions and refresh
rates.
b) Click on the Advanced... button.
You can select your display type from the monitor list, or click on
a new resolution or refresh rate.
c) Restart the computer to make the changes effective.
Hints
When you are using OS/2 or Windows, the
virtual screen
function is available with the ThinkPad Features program. It is
used to display a part of the high-resolution screen image that is
produced by the computer. Other parts can be seen by moving
the screen with the TrackPoint III or other pointing device.
Attention:
Do not disconnect the external
monitor while the computer is in
suspend mode or hibernation mode.
If no external monitor is attached
when the computer resumes, the
LCD will remain blank and the output
will not be displayed. This does not
depend on the resolution value.
3
Connect the external monitor to the computer:
a) Turn off the computer.
b) Attach the external monitor to the external monitor
connector (
) at the rear of the computer and then to
the electrical outlet.
c) Turn on the external monitor and the computer.
When Changing the Display Settings
When you are using OS/2 Warp:
Do not use System in the System Setup folder to change the
resolution or color depth. Use the ThinkPad Features
program to configure the display.
To change the display settings for WIN-OS/2, use the
ThinkPad Features program
in WIN-OS/2.
Chapter 3. Operating Your Computer 43
To Next Page
Loading...
Need help?
General
