v Follow the prompts. You may be prompted to
change CDs.
v When the process is complete, the system reboots.
Continue to step 6 to install preloaded system.
Install preloaded system from CD:
7. Boot with the recovery CD (and the boot diskette if
required.)
8. If the hard-disk drive is blank, the following message
is displayed: “Your computer originally included a
Product Recovery program ... Reinstall the
Product Recovery program? (Y/N) [ ]”.
v To install the service partition, go to step 4.
v To preload the hard-disk drive without installing the
service partition, press N key.
9. If you get a message asking which operating system
to install, select the proper operating system and
press Enter.
10. A message is displayed: “Full Recovery:”. Press
Enter to select.
11. On each of the next three windows, press the Y key.
12. Follow the prompts to complete the recovery.
Passwords
As many as three passwords may be needed for any
ThinkPad computer: the power-on password (POP), the
hard-disk password (HDP), and the supervisor password
(SVP).
If any of these passwords has been set, a prompt for it
appears on the screen whenever the computer is turned
on. The computer does not start until the password is
entered.
Exception: If only an SVP is installed, the password
prompt does not appear when the operating
system is booted.
Power-on password:
A power-on password (POP) protects the system from
being powered on by an unauthorized person. The
password must be entered before an operating system can
be booted.
Hard-disk password:
There are two hard-disk passwords (HDPs):
v User HDP—for the user
v Master HDP—for the system administrator, who can use
it to get access to the hard disk even if the user has
changed the user HDP
Related service information
32 ThinkPad X30, X31 (MT 2672/2673)
To Next Page
Loading...
Need help?
General
