IBM ThinkPad X30, ThinkPad X31 (MT 2672 User Manual

Symptom or error FRU or action, in sequence
0185
Bad startup sequence settings.
Enter BIOS Setup and load
Setup defaults.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save current
setting by pressing F10.
0187
EAIA data access error—The
access to EEPROM is failed.
System board.
0188
Invalid RFID Serialization
Information Area.
System board.
0189
Invalid RFID configuration
information area—The
EEPROM checksum is not
correct.
System board.
0190
Critical low-battery error
1. Charge the battery pack.
2. Battery pack.
0191
System Security—Invalid
Remote Change requested.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
0192
System Security—IBM
Embedded Security hardware
tamper detected.
System board.
0199
System Security—IBM Security
password retry count exceeded.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
01C8
More than one modem devices
are found. Remove one of
them. Press <Esc> to continue.
1. Remove either a Mini-PCI
Card. Otherwise, press
Esc to ignore the warning
message.
2. System board.
01C9
More than one Ethernet devices
are found. Remove one of
them. Press <Esc> to continue.
1. Remove the Ethernet
device that you installed;
or press Esc to ignore the
warning message.
2. System board.
0200
Hard disk error—The hard disk
is not working.
1. Reseat the hard-disk
drive.
2. Load Setup Defaults in IBM
BIOS Setup Utility.
3. Hard-disk drive.
4. System board.
021x
Keyboard error
Run interactive tests of the
keyboard and the auxiliary
input device.
Symptom-to-FRU index
60 ThinkPad X30, X31 (MT 2672/2673)

IBM ThinkPad X30, ThinkPad X31 (MT 2672 Specifications

General

Brand	IBM
Model	ThinkPad X30, ThinkPad X31 (MT 2672
Category	Laptop
Language	English