23
Safety of use
14. If the pump does not operate for a long time, close the ball valves cutting o the
pump and cut o electric power supply.
15.
If the electric wire powering the pump is damaged, refer to an authorised servicing
team to replace it along with its switch.
16. If the pump motor heats up excessively (more than usually), immediately discon-
nect the pump from its power source, close the cut o valves and contact a ser-
vicing team.
17.
If a pump failure cannot be removed according to the manual, immediately dis-
connect the pump from its power supply, close the cut o valves and immediately
contact the local manufacturer or the servicing centre.
18.
The product must be placed in a place far away from children and measures to
isolate the product must be taken to avoid children touching it.
19.
The product must be connected to the electric mains equipped with ecient elec-
tric earthing. The yellow-green core of the connection cable is earthing.
20. The product must be connected to mains equipped with a residual current circuit
breaker with tripping current In not exceeding 30 mA.
21. The product must be placed in a dry, well-ventilated and cool place and stored at
room temperature.
22.
This equipment is not intended for use by persons (including children) with reduced
motor, sensory or mental capacities, or persons without experience or not famil-
iarised with the equipment, unless it is performed under supervision or according
to the instruction regarding operation provided by persons responsible for their
safety. Attention should be paid so that children do not play with the equipment.
To Next Page
Loading...
