Icom IC-455 User Manual

iv
1
7
4
10
15
18
2
8
13
5
11
16
3
9
14
6
12
17
CAUTION: DO NOT use the non-specied
microphone. Other microphones have
di󰀨erent pin assignments and may damage
the transceiver.
CAUTION: Conrm that all connectors and
jacks are dry and clean before attachment.
Exposing them to dust or water will result in
serious damage to the transceiver.
NOTE: DO NOT use or leave the
transceiver in areas with temperatures
below –10°C or above +60°C, or in areas
subject to direct sunlight, such as the
dashboard.
DO NOT push PTT unless you actually
intend to transmit.
DO NOT place the transceiver where hot or
cold air blows directly onto it, during mobile
operation.
KEEP the transceiver away from heavy
rain and never immerse it in water. The
transceiver meets IP54* requirements for
dust-protection and splash resistance.
However, once the transceiver has been
dropped, dust-protection and splash
resistance cannot be guaranteed due to the
fact that the transceiver may be cracked or
the waterproof seal damaged, and so on.
* Except for the rear panel, and only when
the supplied microphone is attached.
NEVER place the transceiver in an
insecure place to avoid inadvertent use by
unauthorised persons.
BE CAREFUL! DO NOT block the air vent
on the bottom panel of the transceiver. This
transceiver has an air vent to meet the IP54
requirements.
BE CAREFUL! The transceiver may
become hot after continuously transmitting
for long periods of time.
MAKE SURE to turn OFF the transceiver
power before connecting any supplied/
optional equipment.
This device complies with
Standard Australia Specication
No. AS/NZS 4365-2011.

Icom IC-455 Specifications

General

Brand	Icom
Model	IC-455
Category	Transceiver
Language	English