Icom IC-7000 Service Manual

4-4 TRANSMITTER ADJUSTMENT (Continue)
ADJUSTMENT ADJUSTMENT CONDITION DISPLAY OPERATION
TX OUTPUT
POWER (HF)
1• Connect an RF power meter to
[ANT1] connector.
• Connect an audio generator to
[MIC] connector and set as;
Level : 1.5 kHz/30 mV
• Transmitting
Po Min(HF)
Set the output power to 1 W using [DIAL].
Then push [F-4 (SET)] .
2
Po Tune(HF)
Set the output power to 10 W using
[DIAL]. Then push [F-4 (SET)].
3
Po 25%(HF)
Set the output power to 25 W using
[DIAL]. Then push [F-4 (SET)].
4
Po 50%(HF)
Set the output power to 50 W using
[DIAL]. Then push [F-4 (SET)].
5
Po(HF APC Low Volt)
Set the output power to 75 W using
[DIAL]. Then push [F-4 (SET)].
6
Po 100%(HF)
Set the output power to 95 W using
[DIAL]. Then push [F-4 (SET)].
7
Po Max(HF)
Set the output power to 105 W using
[DIAL]. Then push [F-4 (SET)] key.
APC (HF) 1
APC(HF)
Push [F-4 (SET)].
TX OUTPUT
POWER (AM)
1• Connect an RF power meter to
[ANT1] connector.
• Apply no audio signal to [MIC]
connector.
• Transmitting
AM POCV Ratio
Set the output power to 35 W using
[DIAL]. Then push [F-4 (SET)].
TX OUTPUT
POWER
(50 MHz)
1• Connect an RF power meter to
[ANT1] connector.
• Connect an audio generator to
[MIC] connector and set as;
Level : 1.5 kHz/30 mV
• Transmitting
Po Min(50 M)
Set the output power to 1 W using [DIAL].
Then push [F-4 (SET)].
2
Po Tune(50 M)
Set the output power to 10 W using
[DIAL]. Then push [F-4 (SET)].
3
Po 25%(50 M)
Set the output power to 25 W using
[DIAL]. Then push [F-4 (SET)].
4
Po 50%(50 M)
Set the output power to 50 W using
[DIAL]. Then push [F-4 (SET)].
5
Po 100%(50 M)
Set the output power to 90 W using
[DIAL]. Then push [F-4 (SET)].
6
Po Max(50 M)
Set the output power to 100 W using
[DIAL]. Then push [F-4 (SET)].
4 - 7

Icom IC-7000 Specifications

General

Input voltage	13.8 V
Microphone included	Yes
Product type	Portable CB radio
Product color	Black
Housing material	-
Frequency range	0.5 - 455000 MHz
Channels quantity	503 channels

Weight and Dimensions

Depth	180 mm
Width	167 mm
Height	58 mm