Icom IC-7000 - Specifications; Receiver Specifications; Transmitter Specifications

SECTION 1 SPECIFICATIONS
1 - 1
¤ GENERAL
• Frequency coverage :
Receive 0.030 – 199.999999 MHz*
1
,
*
2
400.000 – 470.000000 MHz*
1
,
*
2
Transmit 1.800 – 1.999999 MHz*
2
3.500 – 3.999999 MHz*
2
5.260 – 5.405000 MHz*
2
7.000 – 7.300000 MHz*
2
10.100 – 10.150000 MHz
14.000 – 14.350000 MHz
18.068 – 18.168000 MHz
21.000 – 21.450000 MHz
24.890 – 24.990000 MHz
28.000 – 29.700000 MHz
50.000 – 54.000000 MHz*
2
144.000 – 148.000000 MHz*
2
430.000 – 450.000000 MHz*
2
*
1
Some frequency bands are not guaranteed.
*
2
Depending on version.
• Mode : USB, LSB, CW, RTTY (FSK), AM,
FM, WFM (WFM is for receiver only)
• Number of memory ch. : 503 (495 split, 6 scan edges, 2 call)
• Antenna connector : SO-239 × 2
(for HF/50 MHz and 144/430 MHz)/50 Ω
• Power supply requirement : 13.8 V DC ±15% (negative ground)
• Frequency stability : Less than ±0.5 ppm
(0˚C to +50˚C ;+32˚F to +122˚F)
• Current drain :
Transmit at 100 W 22 A
Receive standby 1.3 A
max. audio 1.6 A
• Usable temperature range : –10˚C to +60˚C (+14˚F to +140˚F)
• Dimensions : 167(W) × 58(H) × 180(D) mm
(proj. not included) 6
9
⁄
16
(W) × 2
9
⁄
32
(H) × 7
3
⁄
32
(D) inch
• Weight (approx.) : 2.3 kg (5 lb 1 oz)
• CI-V connectors : 2-conductor 3.5 (d) mm (
1
⁄
8
″)
• Video connector : 2-conductor 3.5 (d) mm (
1
⁄
8
″)
• ACC connector : 13-pin
• Data connector : 6-pin
¤ TRANSMITTER
• Output power :
• Modulation system :
SSB Digital PSN modulation
AM Digital Low Power modulation
FM Digital Phase modulation
• Spurious emissions :
below 30 MHz bands Less than –50 dB
above 50 MHz bands Less than –60 dB
• Carrier suppression : More than 50 dB
• Unwanted sideband : More than 50 dB
• Microphone connector : 8-pin modular jack (600 Ω)
• KEY connector : 3-conductor 6.35 (d) mm (
1
⁄4″)
• RTTY connector : 3-conductor 3.5 (d) mm (
1
⁄
8
″)
¤ RECEIVER
• Receive system :
SSB/CW/AM/FM Triple conversion superheterodyne
WFM Double conversion superheterodyne
• Intermediate frequencies :
• Receive sensitivity : (pre-amp ON)
Note: SSB, CW and AM modes are measured at 10 dB S/N; FM mode at
12 dB SINAD.
*
1
Except 4–4.5 MHz, 8–9 MHz.
*
2
FM mode: 28–29.7 MHz
• Squelch Sensitivity : (pre-amp ON)
SSB Less than 5.6 µV
FM Less than 0.3 µV
• Selectivity : (Sharp filter is selected)
SSB (BW=2.4 kHz) More than 2.4 kHz/–6 dB
Less than 3.6 kHz/–60 dB
CW (BW=500 Hz) More than 500 Hz/–6 dB
Less than 900 Hz/–60 dB
RTTY (BW=350 Hz) More than 360 kHz/–6 dB
Less than 650 kHz/–60 dB
AM (BW=6 kHz) More than 6.0 kHz/–6 dB
Less than 15 kHz/–60 dB
FM (BW=15 kHz) More than 12 kHz/–6 dB
Less than 20 kHz/–60 dB
• Spurious and image rejection ratio:
HF bands More than 70 dB
50 MHz band More than 70 dB (except IF/2 through)
144/430 MHz bands More than 65 dB
(except 144 MHz band IF through)
• Audio output power : More than 2.0 W at 10% distortion
(at 13.8 V DC) with an 8 Ω load
• RIT variable range : ±9.99 kHz
• PHONES connector : 3-conductor 3.5 (d) mm (
1
⁄
8
″)/8 Ω
• EXT SP connector : 2-conductor 3.5 (d) mm (
1
⁄
8
″)/8 Ω
SSB/
CW/
RTTY
AM FM WFM
0.5–1.8 MHz –– 13 µV –– ––
1.8–28 MHz*
1
0.15 µV 2.0 µV
–– ––
28–29.995 MHz*
2
0.5 µV ––
50 MHz band 0.12 µV 1.0 µV 0.25 µV ––
76–108 MHz –– –– –– 10 µV
144/430 MHz
bands
0.11 µV 1.0 µV 0.18 µV ––
1st IF 2nd IF 3rd IF
SSB/CW/AM/
RTTY/FM
124.487 MHz 455 kHz 16.15 kHz
WFM 134.732 MHz 10.700 MHz ––
SSB/CW/
RTTY/FM
AM
1.8–50 MHz bands 2–100 W 1–40 W
144 MHz band 2–50 W 2–20 W
430 MHz band 2–35 W 2–14 W