Icom IC-7100

1
PANEL DESCRIPTION
1-6
@2 SPEECH•LOCK KEY
SPEECH
❍ SPEECH KEY Operation (p. 3-20)
Push to audibly announce the S-meter level, the
displayed frequency and the operating mode.
  •TheS-LevelannouncementcanbeturnedOFFinthe
“S-Level SPEECH” item of the “SPEECH” Set mode.
(p. 6-4)
SET
> SPEECH > S-Level SPEECH
•WhenRITisON,theRIToffsetisnotincludedinthe
frequency announcement.
❍ LOCK KEY Operation (FM sec. 5)
Hold down for 1 second to turn the Lock function
ON or OFF.
  •ThefunctionelectronicallylockstheDial.
  • “
” appears when the function is ON.
  •You can select the Dial lock and Panel lock in the
“Lock Function” item of the “Function” Set mode. (p.
6-6)
SET
> Function > Lock Function
NOTE: The [SPEECH/LOCK] key operation to ac-
tivate the voice synthesizer or the Lock functions
can be replaced in the “[SPEECH/LOCK] Switch”
item of the “Function” Set mode. (p. 6-6)
SET
> Function > Lock Function
@3 MEMO PAD KEY
MPAD
(FM sec. 11)
Push to sequentially call up the contents from the ➥
memo pad.
The 5 (or 10) most recently programmed frequen-
cies and operating modes can be recalled, start-
ing from the most recent.
  •Thememopadcapacitycanbeincreasedfrom5to
10 in
the “Memopad Numbers” item of the “Function”
Set mode (p. 6-6)
SET
> Function > Memopad Numbers
Hold down for 1 second to write the displayed ➥
data into a memo pad.
  •The5mostrecententriesremaininthememopad.
@4 MAIN DIAL
Rotate to change the displayed frequency, select the
Set mode settings, and so on.
@5 MAIN DIAL TENSION LATCH
Select the Dial drag.
 •Threepositionsareselectable.Thetopsettingturnson
clicks as the dial is turned.
Controller — Front panel (Continued)
PBT RIT
TX / RX
PWR
AF RF/SQL
CLR
M-CH BANK
RIT
TUNER/CALL
MENU
MIC/RF PWR
NB
SPEED/PITCH
SET
QUICK
NOTCH
DR
AUTO TUNE RX
�
CS
XFC
SPEECH
MPAD
NR
P.AMP ATT
i7100
@4
@5
@2 @3