Icom IC-7100

5
D-STAR OPERATION <BASIC>
5-16
Using the “Your Call Sign” D
The “Your Call Sign” memory stores the programmed
“UR” (destination) call sign.
When you select an individual station call sign for the
“TO” (Destination) setting using “Your Call Sign,” a gate-
way call can be made.
When you call the destination through a gateway, the
signal is automatically sent to the last repeater that the
station accessed.
So, even if you don't know where the station is, you can
make a call.
NOTE: If the repeater, set to “FROM” (Access Re-
peater) has no Gateway call sign, you cannot make
a gateway call.
Example: Select “TOM” from the “Your Call Sign.”
Push q
DR
(C) to select the DR mode.
Check whether or not “TO” is selected. w
 •If“TO”isnotselected,touchthe“TO”eld.
Touch the “TO” field. e
 •The“TOSELECT”screenappears.
Touch “Your Call Sign.” r
 •The“YOURCALLSIGN”screenisdisplayed.
Touch the destination name or call sign. t
 •Example:“TOM”
 •The transceiver returns to the DR mode screen, and
“TOM” is displayed in “TO.”
After selecting a destination, you can select another
station preset in your transceiver by rotating the Dial
or [M-CH] (L).
The name and call
sign of the selected
station is displayed.
“TOM” is set in “TO.”
Touch the
destination.
( Example:
“TOM”)
“TO” (Destination) setting (Continued)
“TO” is selected.
Touch
“TO.”
Touch
“Your Call Sign.”
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay