Icom IC-7100

5
D-STAR OPERATION <BASIC>
5-15
Using the D “Gateway CQ” (Gateway call)
When“GatewayCQ” isselectedinthe“TOSELECT”
screen,therepeatertomakeagatewayCQcallcanbe
selected from the repeater list.
Example:MakingagatewayCQcallto(Japan;Hama-
cho) from the “Hirano” repeater.
Push q
DR
(C) to select the DR mode.
Check whether or not “TO” is selected. w
 •If“TO”isnotselected,touchthe“TO”eld.
Touch the “TO” field. e
 •The“TOSELECT”screenappears.
Touch“GatewayCQ.” r
 •The“REPEATERGROUP”screenisdisplayed.
Touch the repeater group where your destination re- t
peater is listed.
 •Example:“11:Japan”
Touch the destination repeater. y
 •Example:“Hamacho”
 •The transceiver returns to the DR mode screen, and
“Hamacho” is displayed in “TO.”
After selecting a repeater, you can select another re-
peater preset in your transceiver by rotating [DIAL] or
[M-CH] (L).
Or, you can select another repeater group by rotating
[BANK] (L).
“Hamacho” is set in “TO.”
Touch the desti-
nation repeater
( Example:
Hamacho)
Touch the re-
peater group
( Example:
“11: Japan”)
“TO” (Destination) setting (Continued)
“TO” is selected.
Touch
“TO.”
Touch
“GatewayCQ.”
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay