Icom IC-746PRO - Page 112

DD
Split/Duplex frequency setting
The following data sequence is used when sending/reading
the split or duplex frequency setting.
DD
Repeater tone/tone squelch frequency setting
The following data sequence is used when sending/reading
the DTCS code and polarity setting.
DD
DTCS code and polarity setting
The following data sequence is used when sending/reading
the DTCS code and polarity setting.
Fixed digit: 0 1st digit: 0–7 2nd digit: 0–7 3rd digit: 0–7 Transmit polarity: 0= Normal 1= Reverse Receive polarity: 0= Normal 1= Reverse
q
XX0XX
we
X
100Hz digit: 0–2 10 Hz digit: 0–9
1 Hz digit: 0–9 0.1 Hz digit: 0–9 Fixed digit: 0* Fixed digit: 0*
q*
00XXX
we
X
*Not necessary when setting a frequency.
1 kHz digit: 0—9
100 Hz digit: 0 (fixed) 100 kHz digit: 0—9 10 kHz digit: 0—9 10 MHz digit: 0 (fixed) 1 MHz digit: 0—4 Direction: 00=+ direction 01=— direction
q
0XXXXXX
we
0
r*
*No need to enter for duplex frequency setting.
99
14
CONTROL COMMAND
2001 NEW
IC-746PRO.qxd 02.4.2 11:32 Page 99