46
4
RECEIVE AND TRANSMIT
2001 NEW
DD
Auto repeater function
This function automatically activates the repeater set-
tings (DUP– or DUP+ and/or tone encoder ON/OFF)
when the operating frequency falls within the general
repeater output frequency range and deactivates them
when outside of the range.
Set the auto repeater function ON-1 or ON-2 in set
mode in advance (p. 84). When set ON-1 or ON-2, re-
peater settings are automatically activated according
to the table below.
ON-1 automatically sets the duplex setting and ON-2
automatically sets the duplex setting and tone encoder
automatically.
• Frequency range and offset direction
FREQUENCY RANGE DUPLEX DIRECTION
145.200–145.495 MHz minus duplex
146.610–146.995 MHz minus duplex
147.000–147.395 MHz plus duplex
18
ON-2
Auto
Repeater
18
ON-1
Auto
Repeater
18
OFF
Auto
Repeater
IC-746PRO.qxd 02.4.2 11:31 Page 46
To Next Page
Loading...
