Icom IC-751A - Section 6 General Operation; Settings; Basic Operation

SECTION
6 GENERAL
OPERATION
6
-
1
SETTINGS
•SWITCH AND
CONTROL
6-2
BASIC OPERATION
•
RECEIVING
1)
Power
ON.
After all INSTALLATION instructions
have been
followed
in
SECTION
4,
including connecting
a 50 ohm antenna system, set the
controls and switches as indicated below.
1)
If
a
supply other than the IC-PS35, IC-PS30
or
IC-PS15 is used,
check that
the
AC power supply output
voltage
is 13.8
volts
DC.
2)
Check that
the antenna connector
on the feedline from
the
antenna
is
securely fastened
to the ANTENNA CONNECTOR on
the rear panel of the IC-751
A.
3)
Check all connections between
the IC-751 A and accessory
equip-
ment.
SWITCH/CONTROL
POSITION
POWER OFF
(OUT)
AF GAIN
MAXIMUM
COUNTERCLOCKWISE
RF GAIN MAXIMUM CLOCKWISE
SQUELCH MAXIMUM
COUNTERCLOCKWISE
TONE
CENTER
MIC
GAIN CENTER
RF POWER MAXIMUM
CLOCKWISE
DIAL LOCK OFF
(OUT)
PBT
CENTER
NOTCH
CONTROL: CENTER
SWITCH : OFF
FILTER
OFF
(OUT)
TS OFF (INDICATOR OFF)
DFS OFF
(INDICATOR
OFF)
BAND OFF
(INDICATOR
OFF)
VOX OFF
(OUT)
COMP
OFF
(OUT)
NB WIDE OFF
(OUT)
VOX
GAIN OFF
VOX
DELAY FULL
NB LEVEL OFF
AGC
SLOW
METER
Ic
TRANSMIT/RECEIVE
RECEIVE
SPLIT OFF
(OUT)
This
section
explains
basic
receiving
and transmitting methods.
Refer to SECTIONS
6
-
3
through
6
-
8
for
detailed explanations of
each operating mode.
Before beginning,
confirm all switches and
controls are set
as
stated
in SECTION
6-1
SETTINGS.
1)
Push the POWER SWITCH
to
turn
ON the transceiver. The
FREQUENCY DISPLAY
lights after
about 2 seconds and the
transceiver
is ready for receiving.
-
22
-