Icom IC-9100 - Page 42

• TRANSMIT ADJUSTMENTS (UHF band)
ADJUSTMENT ITEM
TRANSCEIVER'S
CONDITION
OPERATION
MEASURE
POINT
ADJUST
POINT
VALUE
PREPARATION
–
• Connect an AG and millivoltmeter
to [MIC], and then set it as;
Frequency : 1.5 kHz
Level : 1 mV
• Connect a power meter to
[430MHz ANT].
–– –
TX TOTAL GAIN 1 • Display: "Total Gain UHF"
• Receiving
• Push [F-5]. (Automatically starts
to transmit.)
[430MHz
ANT]
[MAIN DIAL] 37.5 W
Push [F-5].
TX POWER & POWER
METER SETTING
2 • Display: "POWER UHF"
• Receiving
• Push [F-5]. (Automatically starts
to transmit.)
– – Push [F-5].
3 • Display: "POWER UHF Min"
• Transmitting
– [144MHz
ANT]
[MAIN DIAL] 1.5 W
Push [F-5].
4 • Display: "POWER UHF 10%"
• Transmitting
7.5 W
Push [F-5].
5 • Display: "POWER UHF 50%"
• Transmitting
37.5 W
Push [F-5].
6 • Display: "POWER UHF 75%"
• Transmitting
60 W
Push [F-5].
7 • Display:
"POWER UHF 100%"
• Transmitting
75 W
Push [F-5].
POWER DOWN SETTING 8
• Display: "POWER Down UHF"
• Transmitting
• Push [F-5]. (Automatically starts
to transmit.)
[430MHz
ANT]
[MAIN DIAL] 37.5 W
Push [F-5].
ALC METER 9 • Display: "ALC UHF"
• Transmitting
• Set the AG as;
Frequency : 1.5 kHz
Level : 10 mV
– – Push [F-5].
(A beep sounds,
and then another
beeps sound
3 sec. later)
DRIVE GAIN 10 • Display: "DRIVE UHF"
• Transmitting
– – Push [F-5].
SWR METER 11 • Display: "SWR UHF-1"
• Transmitting
– – Push [F-5].
12 • Display: "SWR UHF-2"
• Transmitting
• Connect a 25
Ω
dummy load to
[144MHz ANT].
– – Push [F-5].
Automatically returns to the transmit adjustment menu.
4 - 16