9
2
PANEL DESCRIPTION
2
DTMF AUTODIAL KEY “DTMA”
Push to enter the DTMF channel selection mode. Then se- ➥
lect the desired DTMF channel using [CH Up]/[CH Down].
After selecting the desired DTMF channel, push this key to ➥
transmit the DTMF code.
RE-DIAL KEY “DTMR”
Push to transmit the last-transmitted DTMF code.
CALL KEYS “CALL” “CALA” “CALB”
Push to transmit a 2/5-tone/BIIS ID code.
• Call transmission is necessary before you call another station de-
pending on your signaling system.
• [Call A] and/or [Call B] may be available when your system employs
selective ‘Individual/Group’ calls. Ask your dealer which call is as-
signed to each key.
EMERGENCY KEY “EMR”
Push and hold for a specified period to transmit an emer- ➥
gency call.
When [Emergency Single (Silent)] or [Emergency Repeat ➥
(Silent)] is pushed, an emergency call is transmitted with-
out a beep emission and LCD indication change.*
• If you want to cancel the emergency call, push (or push and
hold) the key again before transmitting the call.
• The emergency call is transmitted one time only or repeatedly
until receiving a control code depending on the pre-setting.
*BIIS PMR operation only
SURVEILLANCE KEY “SURV”
Push to turn the surveillance function ON or OFF.
When this function is turned ON, the beep is not emitted and
the LCD backlight does not light when a signal is received or
a key is pushed, etc.
TX CODE ENTER KEY “TXCE”
(PMR or BIIS PMR operation only)
Push to enter the ID code edit mode directly, for both
5-tone and BIIS. Then set the desired digit using [CH Up]/
[CH Down] or 10-keypad*. ((☞ p. 14))
*IC-F3062T/IC-F4062T (10-key type) only
TX CODE CHANNEL SELECT KEY “TXC”
Push to enter the ID code channel selection mode directly. ➥
Then set the desired channel using [CH Up]/[CH Down].
((☞ p. 14))
During ID code channel selection mode, push for 1 sec. to ➥
enter the ID code edit mode for 5-tone and BIIS. Then set
the desired digit using [CH Up]/[CH Down] or 10-keypad*.
((☞ p. 14))
*IC-F3062T/IC-F4062T (10-key type) only
TX CODE CHANNEL UP/DOWN KEYS “TXCU” “TXCD”
Push to select a TX code channel directly.
To Next Page
Loading...
Need help?
General
